heatingoilcost.com

The tank

Tank sizes and ullage

The short answer

A tank does not take its nominal capacity. Deliveries fill to roughly 95%, so a 1,200 litre tank takes about 1140 litres from empty and a 2,500 litre tank about 2375. Subtract what is already in there before you order, or the delivery gets short-filled.

Ullage ceiling

95%

1,200 L tank takes

1140litres

2,500 L tank takes

2375litres

That fill costs

£2,629.36

Ullage is the expansion space left above the fuel. It exists because oil expands when it warms and because a tank needs vapour space above the liquid. Nobody explains it at the point of order, and it is the single most common reason a delivery comes up short of what someone expected.

Common domestic sizes, and what each really takes

Swipe the table sideways for every column

NominalTakes to 95%Cost of that fillTypical setting
1,000 litres950£1,051.74Small house, single occupancy
1,200 litres1140£1,262.09The standard domestic tank
1,360 litres1292£1,430.37Common bunded plastic size
2,500 litres2375£2,629.36Farmhouse or a house that fills once a year
3,500 litres3325£3,681.11Large property or shared arrangement
Fill costs at the published reading of 110.71p. The 95% figure is a working convention used across the trade, not a legal limit, and individual suppliers set their own practice.

Reading the gauge honestly

A sight tube is close to linear. A float and clock gauge is not, and it usually reads optimistically in the bottom third. An electronic gauge is only as good as its calibration. Whatever you have, verify it once against a known delivery: order a measured volume into a tank you have noted the reading on, and see what the gauge says afterwards.

Siting and bunding, in brief

  • A bunded tank sits inside a second shell able to hold at least 110% of the inner tank. Most new domestic installations are bunded.
  • Separation distances from buildings, boundaries and openings are set out in the building control guidance for combustion appliances and fuel storage.
  • A tank near a watercourse, a borehole or a drain is treated more strictly. If you are near any of those, take advice before replacing rather than after.
  • A registered technician should commission the installation and leave you a record. That record is what an insurer will ask for.

The ordering consequence

If your tank is nominally 2,500 litres and reads a quarter full, the orderable volume is about 1750 litres, which is £1,937.43 at today's reading. Ordering the full 2,500 into that tank means the tanker stops early, and depending on the supplier you may still be charged as if you had taken a full delivery slot.

Primary sources for this page

  • Approved Document J, combustion appliances and fuel storage systemsThe building regulations guidance covering domestic oil tank installation and siting in England.
  • OFTECTrade body for the UK oil heating industry. Registration scheme for technicians. Cited for installation practice, not for prices.
  • DESNZ Quarterly Energy Prices, table 4.1.1Monthly typical retail price of standard grade burning oil, the fuel sold to UK households as kerosene. Priced on the Monday nearest the 15th of the month, for deliveries of up to 1,000 litres, VAT at 5% included. The delivery size and the VAT treatment are set by Note 6 of the companion annual table, which is the note this column carries; the 2,000 to 5,000 litre note belongs to gas oil. It is the official UK-wide domestic heating oil price series. DESNZ updates the table once a month, usually in the last week.
  • VAT rates on domestic fuel and powerDomestic heating oil is charged at the reduced rate of 5% on qualifying quantities.